Koolance EXT-400SL-V2-R Uživatelský manuál stáhnout pdf (Strana 25)

Once all of the coolers have been

connected, the system can be ﬁ lled

with coolant. The reﬁ ll plug is located on top of the

reservoir. Remove the large slot-headed screw (with

a screwdriver or large coin).

To avoid damaging the tank threading, never

overtighten the metal reﬁ ll plug when screwing

it back in.

Testing & Filling

WARNING: The liquid coolant is electrically conductive. Use caution

when ﬁ lling the system, and keep all liquids away from computer

hardware and power cables. In case of emergency during installation,

immediately unplug the computer’s rear power cable. Dry the system

thoroughly before proceeding.

Filling & Maintenance

Slowly ﬁ ll the system using the sup-

plied bottle and funnel. To maintain the

product warranty, use only Koolance

approved coolant.

Many alternative “liquid coolants”

and additives can cause permanent

damage to Koolance equipment and

computer hardware.

Do not overﬁ ll the reservoir. It is recommended to keep paper towels on hand just in

case. The liquid coolant should be ﬁ lled up to about 6mm (1/4”) from the reservoir’s

top. This small gap will catch air as it circulates through the system.

Because of gravity, the Exos must be placed above all internal cooling components

while being ﬁ lled. Otherwise, coolant will exit the reﬁ ll plug once the reservoir is

full.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Žádné komentáře

Koolance EXT-400SL-V2-R Uživatelský manuál Strana 25